4 Pin Relay/Fuse Panel With Threaded Connection

4 Pin Relay/Fuse Panel with Threaded Connection

Removing






- Switch off the ignition and remove the ignition key.

- Remove the driver side instrument panel cover.

- Disengage the 3 pin relay/fuse panel by pressing the retaining springs in the - direction of the arrow - and remove the relay/fuse panel - 1 -.

- Mark the electrical wires - 1 and 2 - before removing so they can be installed later.






- Remove the electrical wire - 1 - on the 4 pin relay/fuse panel.

- Release the retaining spring - arrow A - and tilt the relay/fuse panel - 3 - out of the mount - arrow B -.

- On the rear side, remove the electrical wire - 2 - on the 4 pin relay/fuse panel.

- Unclip the fuse panel on relay carrier.

- Remove the relay and control modules.






- Release the retaining clips - arrows - and press the relay carrier - 2 - back and out of the bracket - 1 -.

• The exact assignment of the 4 pin relay/fuse panel with threaded connection can be found in the applicable wiring diagram.

Installing

• Tightening specifications, refer to => [ 4 Pin Relay/Fuse Panel with Threaded Connection, Tightening Specifications ] Relay and Fuse Carrier In Instrument Panel and A-Pillar Overview.

Install in reverse order of removal, observing the following:

- Install the driver side instrument panel cover.