Right Footwell Vent Temperature Sensor (G262)

Right Footwell Vent Temperature Sensor (G262)

• The Right Footwell Vent Temperature Sensor is installed only on vehicles equipped with the "Comfort" A/C system.

Removing

- Move the passenger seats as far back as possible.

- Turn off the ignition.

- Remove the glove compartment.

- Remove the right footwell vent (passenger side) - C -. Refer to => [ Right Footwell Vent ] Right Footwell Vent.

- Disconnect connector - A -.

- Turn the sensor - D - 90° and remove it from the right footwell vent - C -.






Installing

Installation is carried out in the reverse order while observing the following.

- Check the seal - E - for damage and proper seating.

- Install the removed parts in the opposite order.

- Check the Climatronic control module (J255) DTC memory and erase any displayed malfunctions if necessary. Refer to the Vehicle diagnostic tester in "Guided Fault Finding".