Rear Three-Point Seat Belt

Rear Three-Point Seat Belt

• Removal and installation are same for right and left.

Removing






- Remove side trim. Refer to => [ Side Trim ] Side Trim.

- Remove the rear belt anchor. Refer to => [ Rear Belt Anchor ] Rear Belt Anchor.

Rear seat belt igniter:

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Follow all regulations when disposing of pyrotechnic components. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units, Storage, Transporting and Disposal ] Airbag, Belt Tensioner and Battery Cut-Out Units, Storage, Transporting and Disposal.

- Switch the ignition on.

- Disconnect the battery Ground (GND) cable with the ignition switched on.

Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Disconnect electrical harness connector - 3 -.

- To do this, release the connector lock - 3 - using a small screwdriver - 1 - and remove the electrical connector - 3 -.






All Vehicles:






- Remove the bolt - 4 -.

- Thread the seat belt webbing - 2 - downward and remove the three-point seat belt - 1 -.

Installing

- If parts of the seat belt system are removed due to an accident, replace the belt system mounting bolts.

- Insert the three-point seat belt with the anti-twist mechanism in the mount and tighten the bolt.

Rear Seat Belt Igniter:

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

• Make sure the connectors are installed all the way in and are secure.

• Make sure the wires do not get caught.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery Ground (GND) cable with the ignition turned on.

All vehicles:

Further installation is performed in the reverse order of removal.

For the correct tightening specifications, refer to => [ Rear Three-Point Seat Belt Assembly Overview ] Rear Three-Point Seat Belt Assembly Overview.