Airbag Connector

Airbag Connector

Removing






Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

- Remove driver airbag. Refer to => [ Driver Airbag Igniter (N95)/Driver Airbag Igniter 2 (N250) ] Driver Airbag Igniter (N95)/Driver Airbag Igniter 2 (N250).

Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Disconnect the connectors - 4, 6 and 7 -.

- Using a small screwdriver, release the connector retainers - 8 - and remove the connectors - 1 and 2 - for the driver airbag igniter (N95) and for driver airbag igniter 2 (N250).

- Disengage and remove the wire - 3 - on the bracket - 5 -.

Installing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

• Make sure the connectors are installed all the way in and are secure.