Ribbed Belt Drive, Vehicles With Hydraulic Power Steering Overview
Ribbed Belt Drive, Vehicles with Hydraulic Power Steering Overview
1 Ribbed Belt
• Check for wear
• Before removing, mark direction of rotation using chalk or felt-tip marker
• Removing and installing, refer to => [ Ribbed Belt, Vehicles with Hydraulic Power Steering ] Ribbed Belt, Vehicles With Hydraulic Power Steering
• Do not kink
• When installing, make sure it is seated correctly on the ribbed belt pulleys
2 Bolt
• 20 Nm plus an additional 90° turn
• Replace
3 Generator
4 Bolt
5 Idler Roller Cover
6 Idler Roller for Ribbed Belt
• 40 Nm
7 Bolt
8 Bolt
• Tightening specification - item 2 - => [ (Item 2) Bolt ] Coolant Pump, Coolant Thermostat and Connecting Piece Overview
9 Ribbed Belt Pulley for Coolant Pump
• Removing and installing, refer to => [ Coolant Pump ] Coolant Pump
10 Bolt
• Tightening specification - item 1 - => [ (Item 1) Bolt ] Coolant Pump, Coolant Thermostat and Connecting Piece Overview
11 Coolant Pump
• Removing and installing, refer to => [ Coolant Pump ] Coolant Pump
12 Sealing Flange (belt pulley side)
• Removing and installing, refer to => [ Sealing Flange with Crankshaft Seal, Belt Pulley Side ] Service and Repair
13 Bolt
14 Power Steering Pump Bracket
15 Slide Bushing
16 Bolt
17 Power Steering Pump
18 Power Steering Pump Belt Pulley
19 Bolt
20 Ribbed Belt Tensioning Damper
• 40 Nm
• Removing and installing, refer to => [ Ribbed Belt Tensioning Damper, Vehicles with Hydraulic Power Steering ] Ribbed Belt Tensioning Damper, Vehicles With Hydraulic Power Steering
21 Bracket for Air Conditioning Compressor
22 Bolt
23 A/C Compressor
• Do not unfasten/separate refrigerant lines
24 Bolt
25 Alignment Bushing
• Quantity: 2
26 Tensioner Cover
27 Vibration Damper
• With double ribbed belt pulley
• Removing and installing, refer to => [ Vibration Damper ] Service and Repair
Ribbed Belt Pulley Side Sealing Flange - Tightening Specifications and Sequence
- Tighten the bolts - arrows - in a diagonal sequence in stages to 9 Nm.