Rear Crankshaft Main Bearing Seal: Service and Repair

Crankshaft Seal, Transmission Side

Special tools, testers and auxiliary items required

• Assembly Tool (T10122)

• Pulling Hook (T20143/2)

• Assembly Device (T10122/1)

• Pull Sleeve (T10122/2)

Procedure






• The transmission is removed.

- Remove the drive plate. Refer to => [ Drive Plate ] Drive Plate.

- Pry out the with a (T20143/2).

- Clean the running and sealing surface.

- Place the (T10122/1) on the (T10122/2) and slide the shaft seal - A - onto the pull sleeve.






- Remove the assembly device.

- Position the (T10122/2) with shaft seal - 1 - on the crankshaft.






- Press the shaft seal in evenly all around with the thrust piece (T10122/3) until flush.






- Install the drive plate. Refer to => [ Drive Plate ] Drive Plate.