Drive Plate

Drive Plate

Special tools, testers and auxiliary items required

• Counter Hold Tool (10 - 201)

Removing






• The transmission is removed.

- Insert the (10 - 201) to loosen the bolts.

The outer surface of the bearing flange at the drive plate could be damaged.

• Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.

- Remove the bolts, drive plate and sensor wheel.

Installing

Install in reverse order of removal. Note the following:

• Tightening specification, refer to => [ Drive Plate Overview ] Drive Plate Overview.

• Replace bolts that are tightened to the specification.

• There is a needled bearing in the drive plate. Check if the needle bearing is inserted before installing. Needle bearing, removing from and installing on drive plate, refer to => [ Needle Bearing on Drive Plate ] Service and Repair.

- Be careful of the alignment bushings during installation.

- Reposition the (10 - 201) to tighten the bolts.