Hydraulic Pump Fluid Reservoir

Hydraulic Pump Fluid Reservoir

Removing

- Remove hydraulic pump. Refer to => [ Hydraulic Pump ] Hydraulic Pump.

• Before removing, place a cloth or a collector tray under the pump to catch any hydraulic fluid that may leak out.

- Open and close the fluid filler plug one time to equalize the pressure.

- Drain the fluid reservoir if necessary.

- Hold the pump and fluid reservoir upright.






- Loosen the hose clamps - 3 - and remove them.

- Remove oil reservoir - 1 - by lightly turning it off of the valve block - 2 -.

• Do not damage the oil screen - 2 - in the valve block - 1 - when doing so.






Installing

• Tightening specifications, refer to => [ Motor Overview and Hydraulic Pump Fluid Reservoir ] Motor Overview and Hydraulic Pump Fluid Reservoir.

Install in reverse order of removal. Note the following:

• Replace the O-ring.

• Secure all of the hose connections with hose clamps using the corresponding methods. Refer to Electronic Parts Catalog (ETKA).

Note location.

• If the fluid reservoir is replaced, make sure the fluid filler plug is exactly vertical and in the center of the valve block.

• Only then are the MIN and MAX marks correct.

- Install the oil reservoir by lightly turning it onto the valve block.

- Install hydraulic pump. Refer to => [ Hydraulic Pump ] Hydraulic Pump.

- Check the fluid level and fill with fluid if necessary. Refer to => [ Hydraulic System, Filling and Bleeding ] Hydraulic System, Filling and Bleeding.