A-Pillar Upper Trim

A-Pillar Upper Trim

• Removal and installation are same for right and left.

Special tools, testers and auxiliary items required

• Pry Lever - Rmv Outside Mirror (3409)

Removing






- Remove lower roof frame trim. Refer to => [ Roof Frame Trim ] Roof Frame Trim.

- Remove the upper A-pillar trim - 1 - by hand near the rubber seal - 2 - until it is possible to insert the (80 - 200) into the upper clip.

- Using the (80 - 200) , pop the clips out of the A-pillar one after the other - arrows A -.

- Pull the upper A-pillar trim out of the instrument panel - arrow B - and remove.

Installing

Installation is reverse of removal, but note the following:

• If the trim clamps remain in the body mounting points, remove them and insert them in the trim.

• Check clamps for damage or deformation, replace if necessary.

- Insert upper A-pillar trim - 1 - into instrument panel mount and the lower A-pillar trim - arrow -.






- Clip the upper A-pillar trim in and stretch the door seal lip over.