Right Catalytic Converter

Right Catalytic Converter

Removing






• When installing, bring all cable ties back to the same positions.

- Loosen the hose clamps - arrows - and lay the air guide pipe aside with the vacuum hose - 1 - connected.

- Remove the right front muffler. Refer to => [ Front Muffler ] Front Muffler.

- Remove the connector - 1 - for the Oxygen Sensor (O2S) after Three Way Catalytic Converter (TWC) (G130) from the bracket on the right suspension strut tower, disconnect it and free up the wire for the heated oxygen sensor.






• Ignore - 2, 3 and 4 -.

- Remove the bolt - 1 -, the nuts - arrows - and the catalytic converter.






Installing

Install in reverse order, paying attention to the following:

Tightening specifications, refer to:

• => [ Muffler and Catalytic Converter Overview ] Muffler and Catalytic Converter Overview

• => [ Individual Components of Suspension, Right Side ] Muffler and Catalytic Converter Overview

• Replace the seals and self-locking nuts.

• The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

• Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the Parts Catalog.

• To mount the air guide hoses on their connectors securely, spray the bolts on the used clamps with rust remover before installing.

- Install the right front muffler. Refer to => [ Front Muffler ] Front Muffler.