Secondary Air Injection Right Combination Valve

Secondary Air Injection Right Combination Valve

Removing






- Remove the right front wheel.

- Remove the throttle valve control module (J338).

- Remove the connectors - 2 and 3 - from the bracket and move them to the side.






• Ignore - 1 -.

- Disconnect the brake booster vacuum line - 2 -, free it up and lay it on the right side of the vehicle.






• Ignore - 1 -.

- Remove the bolts - arrows - and the heat shield - 1 -.






- Remove the vacuum line - 2 - from the secondary air injection (AIR) combination valve.






- Remove the bolts - 3 -, remove the right secondary air combination valve and remove the bolts - 1 - for the secondary air hose.

Installing

Install in reverse order, paying attention to the following:

Tightening specifications, refer to:

• => [ Secondary Air Injection System Overview ] Service and Repair

• => [ Right Secondary Air Combination Valve Heat Shield - Tightening Specification ] Service and Repair

• Replace the gasket.

• Secure all hose connections with hose clamps of the same type as those equipped by the factory, refer to the Parts Catalog.

- Install the throttle valve control module (J338).

- Install the right front wheel.