Rear Crankshaft Main Bearing Seal: Service and Repair

Crankshaft Seal, Transmission Side

Special tools, testers and auxiliary items required

• Assembly tool (T10122)

• Pulling Hook (T20143)

Procedure






• The transmission is removed.

- Remove the drive plate. Refer to => [ Drive Plate ] Drive Plate.

- Pry the shaft seal out using the (T20143/2).

- Clean the running and sealing surface.

- Place the assembly device (T10122/1) on the pull sleeve (T10122/2) and slide the shaft seal - A - onto the pull sleeve.






- Remove the assembly device.

- Position the (T10122/2) with shaft seal - 1 - on the crankshaft.






- Press the shaft seal in, evenly and flush, using pressure sleeve (T10122/3).






Install in reverse order of removal paying attention to the following:

- Installing drive plate. Refer to => [ Drive Plate ] Drive Plate.