0BKA Transmission

Selector Lever Cable, Bringing into Basic Setting

Special tools, testers and auxiliary items required

• Vehicle Diagnosis Tester

• Pry Lever - Rmv Outside Mirror (80 - 200)

• Socket and Key (T40031)

Procedure

• Guided Fault Finding with the vehicle diagnosis tester is completed; all faults have been corrected.

- Select the following menu options under "Functions/Component selection" in Guided Fault Finding on the vehicle diagnosis tester:

• Drive

• 0BK transmission

• 01 - On Board Diagnostic (OBD) capable systems

• 02-transmission electronics

• 02-Transmission electronics, functions

• 02-measured values

- Select driving mode from the list.

- Compare the following displays:

• Measured value "driving mode" on the vehicle diagnosis tester

• Selector lever position

• Selector lever transmission range position display unit (Y26) on the shift mechanism

• Transmission range display (Y6) in the instrument cluster

Conditions:

• The displays must match

If the displays do not match:

- Adjust the selector lever cable. Refer to => [ Selector Lever Cable, Adjusting ] 0BKA Automatic Transmission.

If the individual displays cannot be reached by adjusting the selector lever cable:

Selector Lever Cable, Bringing into Basic Setting:

• Tightening specification, refer to => [ Selector Lever Cable Overview ] Description and Operation.

- Remove the ball socket - 1 - on the selector lever cable from the selector shaft lever using the (80 - 200).






• Ignore - 1 -.

- Push the selector lever - 1 - on the transmission all the way to the back - arrow - until the parking lock locks into place.






• When parking lock is engaged, it must not be possible to turn the front wheels.

- Push the selector lever into "D".

- Make sure the selector lever inside the vehicle is also in "D".

- Insert the (T40031) through the opening - arrow - in the selector mechanism and loosen the bolt on the selector lever cable one turn.






• Only loosen the clamping screw - do not remove it.

• The clamping screw is only accessible when the selector lever is in "D".

• The selector lever must remain in "D" when the clamping screw is loose.

- Remove the (T40031) from the torque wrench and let it move through the opening - arrow - in the selector mechanism.

- Carefully press the selector lever cable ball socket - 1 - in this position onto the selector shaft lever.






• Do not bend the selector shaft lever when pressing on, otherwise shift mechanism can no longer be adjusted exactly.

• Ignore - 2 -.

- Select 02-measured values in Guided Fault Finding 02 transmission electronics on the vehicle diagnosis tester

- Select driving mode from the list.

- Compare the following displays:

• Measured value driving mode on the vehicle diagnosis tester

• Selector lever position

• Selector lever transmission range position display unit on the shift mechanism

• Transmission range display in the instrument cluster

Conditions:

• The displays must match

- Carefully move the selector forward and back gently without shifting into another selector lever position. This releases the tension in the selector lever cable.






- Tighten the clamping screw in this position with the (T40031) without touching the selector lever.

- Selector mechanism, checking, refer to => [ Selector Mechanism, Checking ] Selector Mechanism, Checking.