Front Final Drive Overview

Front Final Drive Overview

• General repair instructions, refer to => [ Repair Information ] Repair Information.

• Clean working conditions for the automatic transmission, refer to => [ Clean Working Conditions ] Clean Working Conditions.






1 Torque Converter

• Overview, refer to => [ Torque Converter Overview ] Torque Converter Overview

2 Shaft Seal

• For the torque converter

• Removing and installing, refer to => [ Torque Converter Shaft Seal ] Torque Converter Shaft Seal

3 Shaft Seal

• For the left flange shaft

• Between the final drive and the transmission housing

• Removing and installing, refer to => [ Left Flange Shaft Seal ] Left Flange Shaft Seal

4 Adjusting Shim

• Behind the taper roller bearing outer race

5 Taper Roller Bearing Outer Race

6 Bolt

• Tightening specification and sequence, refer to => [ Front Final Drive Cover - Tightening Specifications and Sequence ]

7 Shaft Seal

• For the right flange shaft

• Removing and installing, refer to => [ Right Flange Shaft Seal ] Right Flange Shaft Seal

8 Locking Ring

• Replace

9 Right Flange Shaft

• Removing and installing, refer to => [ Right Flange Shaft ] Right Flange Shaft

10 Drain Plug

• For the hole for checking and filling

• For the transmission fluid inside the front final drive

• Tightening specification - item 2 - => [ (Item 2) Drain Plug ] Gear Oil Drain and Inspection Plugs Overview

11 Cover

• For the front final drive

• Pay attention to the alignment sleeves

• Removing and installing, refer to => [ Front Final Drive Cover ] 0BKA Transmission

12 Adjusting Shim

• Behind the taper roller bearing outer race

13 Taper Roller Bearing Outer Race

14 O-ring

• On the front final drive cover

• Replace

15 Differential

16 Transmission

17 Spring Pin

• Removing and installing, refer to => [ Selector Lever Shaft Seal ] Removal and Replacement

18 Gearshift Lever

• Removing and installing, refer to => [ Selector Lever Shaft Seal ] Removal and Replacement

19 Shaft Seal

• On the selector lever

• Removing and installing, refer to => [ Selector Lever Shaft Seal ] Removal and Replacement

20 Left Flange Shaft

• Removing and installing, refer to => [ Left Flange Shaft ] Left Flange Shaft

21 Bolt

• 24 Nm

• Steel bolt

22 Bracket

• For the left flange shaft

• Removing and installing, refer to => [ Left Drive Flange Ball Bearing ] 0BKA Transmission

23 Ball Bearing

• For the left flange shaft

• Removing and installing, refer to => [ Left Drive Flange Ball Bearing ] 0BKA Transmission

24 Circlip

• Replace

Front Final Drive Cover - Tightening Specifications and Sequence





- Tighten the bolts in two steps in the sequence shown: