Relay and Fuse Panel on Right Side (SF)

Relay and Fuse Panel On Right Side (SF)

Removal






- Turn off the ignition and disconnect the ground cable from the battery. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair.

- Remove the luggage compartment trim panel.

- Remove the nut - 3 -.

- Cut the cable tie - 4 - and free up the wiring harness - 5 -.

- Remove relay and fuse panel F - 2 - from the body - 1 - - arrows -.

- Remove the mount for the 46-pin connector (T46b). Refer to => [ 46-Pin Connector Mount, CAN Cut-Off Connector ] 46-Pin Connector Mount, CAN Cut-Off Connector.






- Open the clip in - direction of arrow - and remove the fuse panel - 2 - from relay and fuse panel F - 1 -.

- Release the retainers - arrows - and remove the relay panel - 2 - from the relay/fuse panel - 1 - to the rear.






- Remove the relay and fuse panel F.

• Check the exact connector assignment in the current wiring diagram.

Installation

• Tightening specification, refer to => [ Luggage Compartment Relay and Fuse Carrier and Control Modules Overview ] Luggage Compartment Relay and Fuse Carrier and Control Modules Overview.

Install in reverse order of removal. Note the following:

- Install the mount for the 46-pin connector (T46b). Refer to => [ 46-Pin Connector Mount, CAN Cut-Off Connector ] 46-Pin Connector Mount, CAN Cut-Off Connector.

- Connect the battery. Refer to => [ Connecting ] Service and Repair.