46-Pin Connector Mount, CAN Cut-Off Connector

46-Pin Connector Mount, CAN Cut-Off Connector

Removal






- Remove the relay and fuse panel inside the luggage compartment on the right side. Refer to => [ Relay and Fuse Panel On Right Side (SF) ] Relay and Fuse Panel on Right Side (SF).

- Slide the locking lever - 2 - into the "open" position - arrow -.

- Press the release - 1 - and push the mount - 3 - toward the rear.

Installation






Install in reverse order of removal. Note the following:

- Slide the locking lever - 1 - on the mount into the "closed" position.

• Both markings - arrows - must align.

- Install the relay and fuse panel inside the luggage compartment on the right side. Refer to => [ Relay and Fuse Panel On Right Side (SF) ] Relay and Fuse Panel on Right Side (SF).