Fuse Panels (ST1)/(ST2)/(ST3)/(ST4)/(ST5)

Fuse Panels (ST1)/(ST2)/(ST3)/(ST4)/(ST5)

Removal






- Turn off the ignition and disconnect the ground cable from the battery. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair.

- Remove the relay and fuse panel F inside the luggage compartment on the right side. The relay mount remains clipped in. Refer to => [ Relay and Fuse Panel On Right Side (SF) ] Relay and Fuse Panel on Right Side (SF).

- Unlock the release and remove from the fuse carrier.

- Remove the fuses from the fuse panel.

- Open the clips - arrows - and remove the fuse panel cover.

- Pull off retaining strip - 1 - for harness connectors - arrow - and remove harness connectors from connector socket.






• Check the exact connector assignment in the current wiring diagram.

Installation

Install in reverse order of removal. Note the following:

- Install the relay and fuse panel F inside the luggage compartment on the right side. Refer to => [ Relay and Fuse Panel On Right Side (SF) ] Relay and Fuse Panel on Right Side (SF).

- Connect the battery. Refer to => [ Connecting ] Service and Repair.