EVAP Canister System Overview

EVAP Canister System Overview






1 Fuel Tank Leak Detection Control Module (J909)

• With an integrated fuel tank pressure sensor (G400)

• Installed location: on the left side at the back of the underbody under the cover

• Removing and installing, refer to => [ Fuel Tank Leak Detection Control Module (J909) ] Fuel Tank Leak Detection Control Module (J909)

2 Bolt

• 1.5 Nm

• Quantity: 3

3 Bolt

• 20 Nm

• Quantity: 3

4 Rubber Grommet

• Quantity: 3

5 Bushing

• Quantity: 3

6 Bracket

7 Nut

• 8 Nm

8 Air Filter

• For the leak detection system

• Installed location: Under wheel housing liner in rear left wheel housing

• Removing and installing, refer to => [ Leak Detection System Air Filter ] Service and Repair

9 Vent Line

• To the air filter for the leak detection system

10 Vent Line

• From the fuel tank

• To disconnect, press release button on connection piece

11 Evaporative Emission (EVAP) Canister

• Installed location: on the left side at the back of the underbody under the cover

• Removing and installing, refer to => [ EVAP Canister ] Service and Repair

12 Vent Line

• To EVAP canister purge regulator valve 1 (N80)

• To disconnect, press release button on connection piece

• Clipped to the bracket

13 Bracket

14 Bolt

• 20 Nm

15 Clamp

• Must be appropriate for the model type. Refer to the Parts Catalog

16 Gasket