Headlamp Fan 2 (V463)/(V464)

Headlamp Fan 2 (V463)/(V464)

Special tools, testers and auxiliary items required

• Protective Gloves

• Protective Eyewear

• Box Cutter

Removal

- Remove headlamp housings. Refer to => [ Headlamp Housing ] Headlamp Housing.

• The headlamp housing must be cut at the designated location with a sharp box cutter to replace the headlamp fan.

• A housing cover can be ordered to seal the assembly opening. Refer to Electronic Parts Catalog (ETKA).

There is a risk of injury and damage.

• Wear protective gloves and eyewear.

• To avoid damaged electrical wires in the headlamp housing, do not cut too deep.

- Cut the cover - 1 - out of the headlamp housing - 2 - with a sharp box cutter.






• Remove any shavings and grit on the blind cover from the headlamp housing.

- Remove the bolts - arrows -.

- Remove the fan - 2 - from the air guide channel - 1 -.






- Disconnect the electrical connector - 3 -.

Installation






• Tightening specification, refer to => [ LED Headlamps Overview ] LED Headlamps Overview.

Install in reverse order of removal. Note the following:

- Close the opening in the headlamp housing - 2 - with the housing cover - 1 - from the repair kit. Refer to Electronic Parts Catalog (ETKA).

- Tighten the bolts - arrows -.

- Install the headlamp housing. Refer to => [ Headlamp Housing ] Headlamp Housing.