Sill Side Trim

Sill Side Trim

Removing






- Move the front seat all the way forward/up.

- Remove the backrest adjustment handwheel. Refer to => [ Backrest Adjustment Hand Wheel ] Backrest Adjustment Hand Wheel.

- Remove the seat height adjustment handle. Refer to => [ Seat Height Adjustment Handle ] Seat Height Adjustment Handle.

- Remove the expanding rivet - 2 - from the sill-side trim - 1 -.

- Carefully remove the trim from the front seat, open the clips - 4 - on the trim and unclip the bracket - 3 -






- Disengage the sill-side rear trim - 1 - from the backrest hinge and lower seat frame.

- Pull the sill-side trim slightly forward off the bracket and remove it upward.

• Be careful not to damage the mounts - 5 - and the tab - 2 - when removing the trim.

- Vehicles with four-way lumbar support: Disconnect the connector - 4 - on the lumbar support adjustment switch - 1 -.






- Remove the sill-side trim - 3 -.

• Ignore - 2 -.

Installation






Install in reverse order of removal. Note the following:

• Make sure the tab - 2 - is seated correctly.

• Make sure the sill side trim - 1 - is engaged correctly on the retaining bracket - 3 - and the locking clips - 4 - are closed.

• Make sure the connectors are installed all the way in and are secure.

Information for installation: for example tightening specifications, replacing body parts, refer to => [ Sill and Tunnel Side Trim Assembly Overview ] Sill and Tunnel Side Trim Assembly Overview.