Seat Cover and Seat Cushion For Multi-Contour Seat, Separating and Connecting

Seat Cover and Seat Cushion for Multi-contour Seat, Separating and Connecting

Special tools, testers and auxiliary items required

• Upholstery clip pliers (V.A.G 1634)

Removing






- Remove seat cover and seat cushion. Refer to => [ Seat Cover with Seat Cushion for Multi-contour Seat ] Seat Cover With Seat Cushion For Multi-Contour Seat.

- Remove seat cover - 1 - from the seat cushion - 2 - and cut upholstery clips - 3 - using pliers.

- Cut the electric wires - arrows - between the heating element on the leg support - 4 - and the seat cover.

• The old heating element remains on the seat cushion and a new heating element (component of the seat cover) is bonded over them.

Installation

Install in reverse order of removal. Note the following:

- Align the new heating element on the leg support.

- Peel the protective film off the heating element. Be careful not to damage the heating element.

- Glue the heating element so that they align with the old heating element and free of wrinkles.

Information for installation: for example tightening specifications, replacing body parts, refer to => [ Seat Cover and Seat Cushion for Multi-contour Seat Assembly Overview ] Seat Cover and Seat Cushion For Multi-Contour Seat Assembly Overview.