Bolster Heater Z31/Z33 For Multi-Contour Seat

Bolster Heater Z31/Z33 for Multi-contour Seat

Driver seat bolster heater (Z31) / front passenger seat bolster heater (Z33)

Removing






- Remove seat bolster cushion. Refer to => [ Seat Cover with Seat Cushion for Multi-contour Seat ] Seat Cover With Seat Cushion For Multi-Contour Seat.

- Disconnect electrical wire - 1 - directly at the old heating elements - 2, 5 -.

• The old heating elements remain on the seat bolster cushion - 3, 4 - and will be covered over by the new heating elements.

Installation

- Align the new heating elements on the seat bolster cushions.

- Remove protective films from the heating elements in succession, taking care not to damage the heating elements.

- Bond heating elements so that they align with the old heating elements and are free of wrinkles.

Installation is performed in reverse order of removal, noting the following:

Information for installation: for example tightening specifications, replacing body parts, refer to => [ Seat Heater and Backrest Heater for Multi-contour Seat, Assembly Overview ] Seat Heater and Backrest Heater For Multi-Contour Seat, Assembly Overview.