Engine Compartment E-Box

Engine Compartment E-Box

Removing






- With the ignition turned off, disconnect the battery ground cable. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

- Remove the windshield wiper motor. Refer to => [ Wiper Motor with Wiper Motor Control Module ] Wiper Motor With Wiper Motor Control Module.

- Remove the bolts - arrows - and the engine compartment E-box cover.

• Ignore item - 1 -.

- Release the retainers - A arrows - and remove the Engine Control Module (ECM) - arrow B -.






- Disconnect the electrical connector - 2 - if applicable.






- Disconnect the electrical connectors - 4 - and remove the electrical wire - 3 - on the front and back side.

- Open the retainers - arrow - and remove fuse panel B - 1 -.

- Disengage the engine wiring harness at the electronics box and lay to the side.

- Remove the alarm horn (H12) if applicable, refer to => [ Alarm Horn ] Alarm Horn and free up the electrical wiring harness.






- Remove the bolts - arrows -.

- Disconnect the electrical connector - 1 - for the brake fluid level warning switch (F34).

- Lift the engine compartment E-box - 3 - and disconnect the clutch position sensor (G476) connector - 2 -.

- Disengage the wiring harness - 1 - on the engine compartment E-box.






- Release the retaining clips - 2 and 5 - and slide the ECM retaining frame - 3 - as far back into the vehicle interior as possible.

- Remove the engine compartment E-box - 4 -.

Installing

• Tightening specifications, refer to => [ Engine Compartment E-Box Bolt Tightening Specification ] Engine Compartment E-Box, Wire Junction, Fuse Holder and Battery Overview.

Install in reverse order of removal, observing the following:

- Install fuse panel B. Refer to => [ Fuse Panel B, Engine Compartment E-Box ] Fuse Panel B, Engine Compartment E-Box.

- Install the alarm horn. Refer to => [ Alarm Horn ] Alarm Horn.

- Connect the battery. Required actions, refer to => [ Connecting ] Battery, Disconnecting and Connecting.

- Install the windshield wiper motor. Refer to => [ Wiper Motor with Wiper Motor Control Module ] Wiper Motor With Wiper Motor Control Module.

- Install the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.