Pendulum Support

Pendulum Support

Removing

Proceed as follows:

- Remove noise insulation in center by loosening fasteners - 1 through 4 -.






- Remove bolts - 1 through 3 - and remove pendulum support.






Install the Pendulum Support

Install in reverse order, paying attention to the following:

• Tightening specifications. Refer to => [ Subframe Mount Overview ] Description and Operation.

Transmission with Threaded Inserts (for Example, "HeliCoil") for Attaching the Pendulum Support





• The holes for the pendulum support on transmissions from 05.28.07 have threaded inserts (for example "HeliCoil").

• Identification: Section on the first coil - arrow -.

• Different tightening specifications => [ (Item 2) Bolts ] Description and Operation.

• Allocate the bolt.

- First tighten pendulum support on transmission - arrow B - and - arrow C - and then on subframe - arrow A -.