Dual Mass Flywheel

Dual Mass Flywheel

Special tools, testers and auxiliary items required

• Flywheel Retainer (3067)

Removing

• Transmission removed.


Risk of destroying dual mass flywheel.

• Remove bolts - B - by hand, not with and air-powered or impact wrench.

• When removing bolts, ensure bolt head does not come in contact with dual mass flywheel.

• Rotate dual mass flywheel - A - so bolts - B - are centered to holes - arrows -.







- Place the (3067) into the hole on the cylinder block - B -, the remove the dual mass flywheel bolts.





- Remove the bolts and the dual mass flywheel.

Installing

• Tightening specifications, refer to => [ Dual Mass Flywheel and Sealing Flange, Transmission Side Assembly Overview ] Dual Mass Flywheel and Sealing Flange, Transmission Side Assembly Overview.

Installation is in reverse order of removal, note the following:

• Replace the dual mass flywheel bolts.

- Place the (3067) into the hole on the cylinder block - A -.