Generation II Steering Gear Rubber Bushing

Generation II Steering Gear Rubber Bushing

Removing






- Remove the bolts - 2 and 3 - and push the heat shield - 4 - slightly upward.

- Loosen the steering gear bolts - 1 and 4 - on the left side of the vehicle.






- Loosen the steering gear bolts - 2 and 3 - on the right side of the vehicle and remove them.








• The subframe and steering gear are shown in their removed position.

- Raise the steering gear - 4 - on the right side of the vehicle up slightly.

- Remove the clamp - 1 - and rubber bushing - 2 - with the bracket - 3 - from the steering gear - 4 -.

Installing

Installation is the reverse of removal, with special attention to the following:

Tightening specifications, refer to => [ Steering Gear Overview, Generation I and II ] Steering Gear Overview, Generation I and II.