FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Seat Height Adjuster Toothed Segment







Seat Height Adjuster Toothed Segment

Special tools, testers and auxiliary items required

Trim removal wedge (3409)





Removing


Follow the safety precautions for pyrotechnic components.

Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove the seat height adjustment motor. Refer to => [ Seat Height Adjustment Motor ] Seat Height Adjustment Motor.

- Using (3409), unclip plastic toothed segment - 2 - from fitting - 1 -.





Installation


Follow the safety precautions for pyrotechnic components.

Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Clip plastic toothed segment - 2 - into fitting - 1 -.





- Make sure the clip - arrow A - and plastic toothed segment collar and the locking pins - B arrows - are inserted correctly in the holes on the fitting - 1 -.

- Make sure the plastic toothed segment is clipped to the fitting correctly.

The plastic toothed segment collar - arrow C - must lie evenly on the fitting.

- Make sure the locking pins - A arrows - are inserted correctly in the holes - B arrows - on the link plate - 1 -.





Further installation is performed in reverse sequence of removal, but observe the following:

Ensure that electrical connections are pushed in as far as stop and engage with a click.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.

Tightening specifications, refer to => [ Seat Pan and Seat Adjustment Controls Component Overview ] Seat Pan and Seat Adjustment Controls Component Overview.