Front Final Drive Overview

Front Final Drive Overview

• Clean working conditions for the automatic transmission. Refer to => [ Clean Working Conditions ] Clean Working Conditions.

• General repair instructions, refer to => [ Repair Information ] Repair Information.






1 Right Flange Shaft

• Refer to => [ Right Flange Shaft ] Right Flange Shaft

2 Locking Ring

• Replace

3 Shaft Seal

• For the right flange shaft

• Refer to => [ Right Flange Shaft Seal ] Right Flange Shaft Seal

4 Drain Plug

• For the hole for checking and filling

• For the transmission fluid inside the front final drive

• Tightening specification - 2 - => [ Drain Plug ] Gear Oil Drain and Inspection Plugs Overview

5 Cover

• For the front final drive

• Pay attention to the alignment sleeves

6 Adjusting Shim

• Behind the taper roller bearing outer race

7 Taper Roller Bearing Outer Race

8 O-ring

• On the front final drive cover

• Refer to => [ Front Final Drive Cover O-ring ] Front Final Drive Cover O-Ring

9 Differential

10 Transmission

11 Shaft Seal

• For the transmission shift lever

• Refer to => [ Selector Lever Shaft Seal ] Removal and Replacement

12 Gearshift Lever

• Removing and installing, refer to => [ Selector Lever Shaft Seal ] Removal and Replacement

13 Spring Pin

• Removing and installing, refer to => [ Selector Lever Shaft Seal ] Removal and Replacement

14 Left Flange Shaft

• Refer to => [ Left Flange Shaft ] Left Flange Shaft

15 Bolt

• 9 Nm plus an additional 60° turn

• Replace

16 Gear Carrier

• Use the circlip to attach together with the mount - 17 - and - 18 - to the left flange shaft.

• Is identified together as the left flange shaft mounting bracket.

17 Bearings

• For the left flange shaft

18 Circlip

• For the left flange shaft mount

19 Torque Converter

• Refer to => [ Torque Converter ] Torque Converter

20 Shaft Seal

• For the torque converter

• Refer to => [ Torque Converter Shaft Seal ] Torque Converter Shaft Seal

21 Shaft Seal

• For the left flange shaft

• Between the final drive and the transmission housing

• Refer to => [ Left Flange Shaft Seal ] Left Flange Shaft Seal

22 Adjusting Shim

• Behind the taper roller bearing outer race

23 Taper Roller Bearing Outer Race

24 Bolt

• Quantity: 11

• Tightening specification and sequence

Front Final Drive Cover - Tightening Specifications and Sequence

- Tighten the bolts in two steps in the sequence shown: