EVAP Canister and Leak Detection System Overview

EVAP Canister and Leak Detection System Overview






1 Vacuum Line

• To engine

2 Clamp

• Must be appropriate for the model type, refer to the Electronic Parts Catalog (ETKA)

3 Ventilation Line

• To the Leak Detection Pump (LDP) (V144) air filter

4 Bolt

• 4 Nm

5 Bolt

• 16 Nm

6 Rubber Grommet

7 Bushing

8 Bracket

• For the Evaporative Emission (EVAP) canister

9 EVAP Canister

• Installed location: In the bottom of the spare wheel well

• Removing and installing, refer to => [ Evaporative Emission (EVAP) Canister ] Evaporative Emission (EVAP) Canister

10 Vent Line

• To fuel tank

• To disconnect, press release button on connection piece

11 Vent Line

• To EVAP canister purge regulator valve 1 (N80)

• To disconnect, press release button on connection piece

12 Gasket

13 Leak Detection Pump (LDP) (V144)

• Installed location: On the underbody under the rear underbody panel, on the left side

• Check in "Guided Fault-Finding" operating mode using the vehicle diagnostic tester

• Removing and installing, refer to => [ Leak Detection Pump (LDP) (V144) ] Leak Detection Pump (LDP) (V144)

Leak Detection Pump (LDP) (V144) Air Filter - Tightening Specification





- Tighten the nut - 2 - to 5 Nm.