Trim, Sill Side

Trim, Sill Side

• Removal and installation can be done with seat installed.

Removing






- Tilt seat all the way up.

- Remove backrest adjustment wheel. Refer to => [ Backrest Adjusting Wheel ] Backrest Adjusting Wheel.

- Remove seat height adjustment handle. Refer to => [ Seat Height Adjustment Handle ] Seat Height Adjustment Handle.

- Remove the screw - 3 - and the remove the trim spreader clip - 2 -.

- Disengage the rear trim - 1 - on the seat - arrow A -.

- Pull the trim slightly toward the rear, remove it from the bracket- 3 - and then remove it forward - arrow B -.

- Vehicles with a four-way lumbar support: disconnect the connector - 4 - on the lumbar support adjustment switch - 1 -.






• Ignore - 2 -.

- Remove the trim on the sill side - 3 -.

Installation

Installation is reverse of removal, but note the following:

• Make sure the trim on the sill side is correctly attached to the mounting bracket.

• Make sure the wire is as close as possible to the connector - 4 - as possible.

Tightening specifications, refer to => [ Sill Side Trim Overview ] Sill Side Trim Overview.