Washer Fluid Reservoir Filler Neck

Washer Fluid Reservoir Filler Neck

Removing






- Remove the bolts - 3 -.

- Remove the clips - 2 - from the mounts and remove the plenum chamber cover- 1 -.

- Remove the nut - 1 - and tilt the windshield wiper fluid container filler tube slightly upward - arrow A -.






- Remove the filler neck - 2 - with filler tube from the washer fluid reservoir and the body opening - arrow B -.

Installing






• Tightening specification, refer to => [ Washer Fluid Reservoir, Lines and Nozzle Overview ] Removal and Replacement.

Install in reverse order of removal, observing the following:

- Slide the sealing grommet - 2 - on the filler neck tube - 1 - as far as the stop.

• The tab must lie in the opening on the filler tube - arrows -.

- Slide the filler neck into the washer fluid reservoir.

• Make sure the O-ring is not crushed when sliding it into the washer fluid reservoir.