Drive Plate

Drive Plate

Special tools, testers and auxiliary items required

• Counter Hold Tool (10 - 201)

Removing

• Transmission removed.

- Insert the (10 - 201) to loosen the bolts.






- Remove the bolts and then remove the washer, the drive plate and the shim behind them.

- Vehicles built from 06.10: Install the sensor wheel for the engine speed (RPM) sensor (G28).

Installing

Install in reverse order of removal. Note the following:

• Tightening specifications, refer to => [ Drive Plate Overview ] Drive Plate Overview

• Replace the drive plate bolts.

- Vehicles built through 05.10: Place the 1.5 mm shim on the crankshaft.

- Be careful of the alignment bushings when installing the other parts.

- Position the (10 - 201) to tighten the bolts.