Rear Crankshaft Main Bearing Seal: Service and Repair

Crankshaft Seal, Transmission Side

Special tools, testers and auxiliary items required

• Assembly Tool (T10122)

• Pulling Hook (T20143)

Procedure

• Transmission removed.

- Remove the drive plate. Refer to => [ Drive Plate ] Drive Plate.

- Pry the shaft seal out with the (T20143/2).






- Drill a 8 mm - arrow 2 - hole in the guide sleeve (T10122/2) for the alignment sleeve; use the hole in the washer as a template - arrow 1 -.






- Clean running and sealing surface.

- Place the assembly device (T10122/1) on the pull sleeve (T10122/2) and slide the shaft seal - A - onto the pull sleeve.






- Remove the assembly device.

- Position the (T10122/2) with shaft seal - 1 - on the crankshaft.






- Press the shaft seal in, evenly and flush, using the pressure sleeve (T10122/3).






- Installing drive plate. Refer to => [ Drive Plate ] Drive Plate.