Selector Shaft Seal, Transmission Replaced not Disassembled

Selector Shaft Seal, Transmission Replaced not Disassembled

• It is possible to remove it when the transmission still installed. Refer to => [ Selector Shaft Sealing Ring, with Transmission Installed ] Selector Shaft Sealing Ring, With Transmission Installed.

Special tools, testers and auxiliary items required

• Sleeve (VW 423)

• Extractor Lever (T20143/1)

• Assembly Sleeve (01E 311 120)

• Sealing Grease (G 052 128 A1)

Removing

• Selector shaft installed

- Carefully pry off sealing ring without damaging shaft.





• Selector shaft removed

- Carefully pry out the seal with a screwdriver or Extractor Lever (VW 681).





Installing

- To prevent damage to the seal - C -, the installation of the seal and selector shaft must only be performed with the Assembly Sleeve (01E 311 120) - A -.





- Fill area between sealing lip and dust lip halfway with Sealing Grease (G 052 128 A1).

- Lightly oil outer circumference of seal.

- Install the sealing ring - arrow - into the housing up to the stop.