Oil Pan and Oil Pump Component Overview

Oil Pan and Oil Pump Component Overview





1 Oil pan

• Removing and installing, refer to => [ Oil Pan ] Oil Pan

• Install with sealant

2 Torque bracket

3 23 Nm

4 Oil pump

• With pressure relief valve 12 bar

• Removing and installing, refer to => [ Oil Pump ] Oil Pump

• Before installing, check to be sure both alignment bushings => [ (Item 12) Fitting sleeves ] are present (for centering oil pump/cylinder block)

• Replace if running surfaces and gears are scored

• Tightening specification oil pump cover to oil pump housing: 10 Nm

5 Chain sprocket for oil pump

• Can only be positioned one way on the oil pump shaft

6 22 Nm

7 Drive chain for oil pump

• Mark direction of rotation before removing

• Check for wear

8 15 Nm

9 Sealing flange, front

• Must be located on dowel sleeves

• Removing and installing, refer to => [ Front Sealing Flange ] Service and Repair

• Install with sealant.

• Seal for crankshaft - ribbed belt side, replacing, refer to => [ Crankshaft Seal, Belt Pulley Side ] Service and Repair

10 Chain tensioner

• Tighten to 16 Nm.

• Do not disassemble

• Note installation position

• When installing, pretension spring and hook in

• If the spring is broken, replace the chain tensioner completely

11 Chain sprocket for oil pump

• Removing and installing, refer to => [ Chain Sprocket ] Service and Repair

12 Fitting sleeves

• 2 pieces

13 O-ring

• Replace

14 16 Nm

15 Suction line

• Clean strainer if contaminated

16 Oil baffle

17 16 Nm

18 15 Nm

• Fasten diagonally in steps

• Observe tightening sequence => [ Install oil pan immediately and tighten the
bolts in the described sequence: ] Oil Pan

19 40 Nm

20 Seal

• Replace

21 Gasket

• Replace

22 Oil return line

• From turbocharger

23 10 Nm

Oil spray jet and pressure relief valve





1 Oil spray jet (for piston cooling)
2 Bolt with pressure relief valve - 27 Nm

• Opening pressure 1.3 to 1.6 bar.