Oil Pan, Oil Strainer and Mechatronic Overview

Oil Pan, Oil Strainer and Mechatronic Overview


Do not let the engine run or tow the vehicle when the oil pan is removed or when there is no ATF in the engine.

• Always replace the Mechatronic unit if it is dirty or faulty.

• Automatic transmission clean working conditions, refer to => [ Clean Working Conditions ] Clean Working Conditions.

• General repair instructions, refer to => [ General Repair Information ] General Repair Information.

• Coat O-rings and seals with ATF. Other types of lubrication lead to faults in the transmission hydraulics.






1 Bolt

• 11 Nm

• For attaching the oil pan to the transmission

• Follow the tightening specifications and sequence, refer to : => [ Oil Pan ] Oil Pan.

2 ATF Drain Plug

• Always replace plug.

• 12 Nm

3 ATF Inspection Plug

• 80 Nm

4 O-ring

• Always replace

5 Fluid Pan

• Refer to => [ Oil Pan ] Oil Pan

6 Magnet

• Ensure full surface contact

• Clean before installation

7 Cover Cap

• Inserted in oil pan opening

8 Magnet

• Ensure full surface contact

• Clean before installation

9 Oil Pan Seal

• Always replace

10 Oil Screen

• Refer to => [ Oil Screen ] Oil Screen

11 O-ring

• Always replace

12 Wiring Harness Connector Clip

13 Wiring Harness in Transmission

• Refer to => [ Wiring Harness in Transmission ] Wiring Harness In Transmission

14 Bolt

• 8 Nm

• Following removal and installation instructions, refer to => [ Mechatronic Unit ] 09EA Transmission

15 Mechatronic

• Refer to => [ Mechatronic Unit ] 09EA Transmission

16 Seal