With Manufacturer's Scan Tool

Diagnostic Trouble Code (DTC) Memory, Erasing

NOTE: If it is not possible to erase DTC memory, check it once again and repair malfunctions.

Preconditions:
- Diagnostic Trouble Code (DTC) memory checked. With Manufacturer's Scan Tool
- All malfunctions repaired.

After DTC memory has been successfully checked:

Display on VAS 5051:







- Under -1- select diagnostic function "05 - Erase Diagnostic Trouble Code (DTC) memory".

Display on VAS 5051:







1 - No display (before erasing)
or
- Diagnostic Trouble Code (DTC) memory erased

NOTE: The following message appears in display field -1-: "Diagnostic Trouble Code (DTC) memory not yet checked", if the operational sequence was not exactly performed. The Diagnostic Trouble Code (DTC) memory can only be erased, if the Diagnostic Trouble Code (DTC) memory has been checked beforehand.

2 - Note: Is the function to be carried out?
Note: Data will be erased

- Press -OK- button in display -2-.
- Exit function "05 - Erase Diagnostic Trouble Code (DTC) memory" by pressing <- button.
- Check Diagnostic Trouble Code (DTC) memory again after performing repairs.

NOTE: This erases malfunctions that have been stored while the malfunction was being repaired, for example, malfunctions that have arisen as a result of connectors being disconnected.

- If the Diagnostic Trouble Code (DTC) memory has been erased, reset the readiness code. Readiness Code, Generating