Accessory Control Display: Service and Repair

Interface Dial Removal/Installation

SRS components are located in this area. Review the SRS component locations, Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.

- Take care not to scratch the dashboard and related parts.

- Lay a shop towel under the parts when working on them to protect the face panel from scratches or other damage.

- Eject the disc before removing the audio-navigation unit to prevent damaging the CD/DVD player's load mechanism.

- If the audio-navigation unit is replaced or disconnected, a Map Matching must be done. How to Troubleshoot the Navigation System (With Navigation)

1. Remove the audio-navigation switch panel. Audio-Navigation Switch Panel Removal/Installation (With Navigation)

2. Remove the bolts (A) and stays (B).

3. Remove the screw and harness cover (C).






4. Disconnect the interface dial 13P connector (A).

5. Remove the 4 screws (B), then pry the interface dial (C) away from the audio-navigation switch panel with two KTC trim tools and applying even force as shown.
NOTE: Apply pressure slowly and steady until the knob and dial pops off.






6. Remove the interface dial (A), from the audio-navigation switch panel.

7. Install the dial in the reverse order of removal.
NOTE: If the hard buttons do not work, but the jog dial does, recheck the interface dial connector connection.