Power Seat Motor Position Sensor: Service and Repair

Front seat position sensor

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Removing the front seat
Remove the front seat. See: Front seat Front Seat.

Removal

Removing seat track sensor (STS)




Remove the locking pin for the sensor.

Hint: Screw a small panel screw into the locking pin. Use cutting pliers to pull it out.

Remove the seat track sensor (STS).

Note! Make a note of how the wiring is routed.




Bend the catch for the connector to one side. Press out the connector. Remove the connector.

Installation

Installing the seat track sensor (STS)

Install:
- the sensor
- the snap ring
- the connector.

Caution! Route the wiring as noted earlier. Route the wiring so that it does not rub or is pinched.

Install the front seat. See: Front seat Front Seat.