Signal Too Low

Signal too low

Checking components and wiring








- Switch off the ignition. Wait 10 seconds
- Disconnect the connector from the passenger seat belt (inertia) reel sensor
- Disconnect the connectors from the supplemental restraint system module (SRS).

Caution! Do not touch the terminal pins in the supplemental restraint system module (SRS). There is a risk of static discharge. This could damage the supplemental restraint system module (SRS).

Check the connectors to the seat belt (inertia) reel sensor and the supplemental restraint system module (SRS). Check for damage to pins and terminals in the connectors.
Remedy as necessary.
Check the cable between the supplemental restraint system module (SRS) and the seat belt (inertia) reel sensor connector. Check for a short-circuit to ground.
Check the cable between:
- Supplemental restraint system module (SRS) terminal #A70 and seat belt (inertia) reel sensor connector terminal #1
- Supplemental restraint system module (SRS) terminal #A71 and seat belt (inertia) reel sensor connector terminal #2.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS)
- Signal specification Signal Specification
- For further information about cable routing and terminals, see the wiring diagram
- To access or replace the supplemental restraint system module (SRS) and the connectors. See: Air bag supplemental restraint system Service and Repair
- Front safety belt retractor Front Safety Belt Retractor
- For information about the repair of SRS wiring, see: Wiring harness supplemental restraint system (SRS) Wiring Harness Supplemental Restraint System (SRS)
- Checking wiring and terminals Checking Wiring and Terminals

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Switch off the ignition. Wait 10 seconds
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead. Wait 10 seconds.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking components and wiring

-------------------------------------------------