Signal Too Low

Signal too low

Checking the status




- Ignition on.
Check the outside temperature.
Check if the fault is permanent or intermittent.

Note! The outside temperature sensor is always located in the left-hand door mirror, regardless of whether the vehicle is left or right-hand drive.

The fault is permanent if the outside temperature is not correct.
If the outside temperature is correct, this is an indication that the fault was present previously but that it is not active at the moment, i.e. the fault is intermittent.

Is the temperature within its permitted range?

Yes - Verification

No - Checking the component and wiring

-------------------------------------------------

Checking the component and wiring




- Ignition off.

Note! The outside temperature sensor is always located in the left-hand door mirror, regardless of whether the vehicle is left or right-hand drive.

Check the Central electronic module (CEM) connector terminal #F28 and #F31. Check for contact resistance and oxidation.
Check the Driver door module (DDM)/Passenger door module (PDM) connector terminal #A17 and #A8. Check for contact resistance and oxidation.
Check the outdoor temperature sensor connectors #1 and #2. Check for contact resistance and oxidation.
Check for damage carefully.
Also check the intermediate connectors. Check for contact resistance and oxidation Check for damage carefully.
Check the signal cable between the Central electronic module (CEM) and the Driver door module (DDM) /Passenger door module (PDM). Check for a short-circuit to ground.
Take readings between:
- Central electronic module (CEM) terminal #F31 (#31) and Driver door module (DDM) /Passenger door module (PDM) terminal #A8 (#8).
Check the ground cable between the Central electronic module (CEM) and the Driver door module (DDM) /Passenger door module (PDM). Check for a short-circuit to ground.
Take readings between:
- Central electronic module (CEM) terminal #F28 (#28) and Driver door module (DDM) /Passenger door module (PDM) terminal #A17 (#17).
Check the signal cable between the Driver door module (DDM) /Passenger door module (PDM) and outdoor temperature sensor. Check for a short-circuit to ground.
Take readings between:
- The Driver door module (DDM)/Passenger door module (PDM) terminal #B1 (#22) and outdoor temperature sensor connector terminal #1.
Check the ground cable between the Driver door module (DDM) /Passenger door module (PDM) and outdoor temperature sensor. Check for a short-circuit to ground.
Take readings between:
- The Driver door module (DDM)/Passenger door module (PDM) terminal #B2 (#21) and outdoor temperature sensor connector terminal #2.
Remedy as necessary.

Other information
- For connecting breakout box to Central Electronic Module (CEM): Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Connecting the breakout box, driver door module / passenger door module (DDM/PDM) Connecting the Breakout Box, Driver Door Module / Passenger Door Module (DDM/PDM)
- For a signal description for the central electronic module (CEM),
- For signal specification Driver door module (DDM)/Passenger door module (PDM): Signal specification Signal Specification, Driver's Door Module / Passenger Door Module (DDM/PDM)
- Outside temperature sensor door mirror, replacing
- Panel front door Removal and Replacement
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Read off the sensor signal by clicking the VCT2000 symbol.
Check that the value is between 0.15 and 4.85 volts.





Is the value OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the component and wiring

-------------------------------------------------