Incorrect Keypad Installed

Incorrect keypad installed

Checking the component




- Ignition on.
The fault is because the Volvo On Call switches were mistakenly connected to a phone module (PHM) without Volvo On Call functionality.
To check whether the phone module (PHM) in the vehicle is prepared for Volvo On Call functionality, click on the VCT2000 symbol.
Remedy as necessary.

Other information:
- Signal specification Signal Specification, Phone Module (PHM)
- Connecting the breakout box Connecting the Breakout Box, Phone Module (PHM)
- Location of components Location of Components, Phone Module (PHM)
- Phone Module (PHM) Phone Module (PHM)
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Activate the carphone.
Make a call so that both the handset and the hands-free system are used. See the instruction manual.
Ignition off.
Ignition on.
Read off the diagnostic trouble codes (DTCs).
Check that the relevant diagnostic trouble code (DTC) has switched status from permanent to intermittent fault.





Has the status of the diagnostic trouble code (DTC) changed?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component

-------------------------------------------------