Steering Column Control Module: Service and Repair

Steering wheel module (SWM), replacing

Removal

Steering wheel module (SWM)
Remove the steering wheel. See Steering wheel, replacing Steering Wheel, Replacing. Remove the steering column covers. See Replacing the steering column covers Service and Repair





Remove:
- 2 screws
- the connectors
- the control module with stalks and the contact reel by releasing the catches on the underside
- windscreen wiper and direction indicator stalks. See Washer / wiper switch, replacing Service and Repair and Turn signal switch, replacing, TF-80SC AWD, AW50/51 AWD, M66 AWD Service and Repair
- the contact reel. See Contact reel / steering wheel angle sensor, replacing Contact Reel/Steering Wheel Angle Sensor, Replacing
The control module is now exposed.

Installation

- the contact reel and steering wheel angle sensor. See Contact reel / steering wheel angle sensor, replacing Contact Reel/Steering Wheel Angle Sensor, Replacing
- windscreen wiper and direction indicator stalks. See Washer / wiper switch, replacing Service and Repair and Turn signal switch, replacing, TF-80SC AWD, AW50/51 AWD, M66 AWD Service and Repair
- the control module with the levers and contact reel. Check that the hooks engage underneath
- the connectors
- 2 screws. Tighten
- the steering column covers. See Replacing the steering column covers Service and Repair
- the steering wheel. See Steering wheel, replacing Steering Wheel, Replacing

Programming the control module
Program the new control module. See the table below:

Note! Vehicles up to and including model year 2004 must be loaded with Steering wheel module (SWM) software. Vehicles from and including model year 2005 must only be loaded with Steering wheel module (SWM) software if the vehicle has DSTC.