Contact Reel/Steering Wheel Angle Sensor, Replacing

Contact reel/steering wheel angle sensor, replacing

As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the essential information in the illustrations is always correct.

Preparations




Disconnect the battery lead. See Battery, disconnecting Battery Disconnecting.

Removing the contact reel and steering wheel angle sensor





Remove:
- the steering column covers. See Replacing the steering column covers Service and Repair
- the steering wheel. See Steering wheel, replacing Steering Wheel, Replacing.
Disconnect the left connector.

Remove:
- four screws
- the contact reel.

Installing the contact reel and steering wheel angle sensor

Note! For tightening torques, see [1][2]Specifications

Install:
- the contact reel
- the 4 M5 screws. Tighten
- the connector.
Zero the contact reel. See Contact reel driver airbag module, resetting Adjustments.

Install:
- the steering wheel. See Steering wheel, replacing Steering Wheel, Replacing
- the steering column covers. See Replacing the steering column covers Service and Repair.