Signal Too High/Signal Missing

Signal too high / Signal missing

Checking the component and wiring




- Ignition off
- Disconnect connector A from the phone module (PHM)
- Disconnect the connector for the Volvo On Call switch.

Hint: There is probably a short-circuit to supply voltage in one of the cables if the ON CALL/SOS switch lights too brightly. There is probably an open-circuit in the cables if the ON CALL/SOS switch does not light at all.

Check the cables for control module connector A for lighting the switch. Check for a short-circuit to supply voltage.
Check between:
- terminals #3 (#3) and #5 (#5)
- terminals #4 (#4) and #5 (#5).
Check the cables for lighting the switch. Check for an open-circuit.
Check between:
- control module connector A terminal #4 (#4) and the connector for switch terminal #4 (#16)
- control module connector A terminal #3 (#3) and the connector for switch terminal #3 (#15).
Try replacing the switch if the cables are OK.
Remedy as necessary.

Other information:
- For further information about the fuses and relays, see the Wiring Diagram
- Connecting the breakout box Connecting the Breakout Box, Phone Module (PHM)
- Location of components Locations
- Phone module (PHM), replacing Phone Module (PHM), Replacing
- Switch Volvo On Call, replacing Switch Volvo on Call, Replacing
- Checking wiring and terminals Checking Wiring and Terminals









Select Continue.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Activate the carphone.
Make a call so that both the handset and the hands-free system are used. See instruction manual.
- Ignition off.
- Ignition on.
- Read off the diagnostic trouble codes (DTCs).
- Check that the relevant diagnostic trouble code (DTC) has switched status from permanent to intermittent fault.





Has the status of the diagnostic trouble code (DTC) changed?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component and wiring

-------------------------------------------------