Signal Too Low
Signal too low
Checking the component and wiring
- Ignition off
- Disconnect connector A from the phone module (PHM).
Check control module connector A for the microphone signal cable. Check for a short-circuit to ground.
Check between:
- terminals #19 (#19) and #18 (#18)
- terminals #19 (#19) and #6 (#6).
Try replacing the carphone handset if no fault is found in the wiring.
Remedy as necessary.
Other information:
- For further information about the fuses and relays, see the Wiring Diagram
- Connecting the breakout box Connecting the Breakout Box, Phone Module (PHM)
- Location of components Locations
- Phone module (PHM), replacing Phone Module (PHM), Replacing
- Handset, replacing Handset, Replacing
- Checking wiring and terminals Checking Wiring and Terminals
Select Continue.
Continue - Verification
-------------------------------------------------
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Activate the carphone.
Make a call so that both the handset and the hands-free system are used. See instruction manual.
- Ignition off.
- Ignition on.
- Read off the diagnostic trouble codes (DTCs).
- Check that the relevant diagnostic trouble code (DTC) has switched status from permanent to intermittent fault.
Has the status of the diagnostic trouble code (DTC) changed?
Yes - Troubleshooting procedure complete
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit Fault-tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking the component and wiring
-------------------------------------------------