Trunk / Liftgate Latch Release Cable: Service and Repair

Luggage Compartment Lid Release Cable

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the side panel
Remove the side panel on the left side of the rear seat. See Side panel rear seat Side Panel Rear Seat.

Removing the cover plate




Move aside the insulating mat.

Remove:
- the 14 M8 screws of the cover plate
- the cable harness clips
- the cover plate connectors
- the styrofoam.






Removing the cable.

Remove:
- the side panel on the left side of the cargo compartment. See Side panel loadspace Side Panel Loadspace
- the trunk lid lock mechanism. See Door latch, luggage compartment lid Door Latch, Luggage Compartment Lid
- the trunk lid lock cylinder. See Liftgate lock cylinder Service and Repair Liftgate lock cylinder Service and Repair.

Note! Note the routing of the mechanical cable.

Detach the clip mountings in the body.

Hint: Secure the new cable in the old before it is removed. Allow the new cable to follow along when the old one is removed.

Pull out the cable rearward in the vehicle.

Installation

Note! For tightening torques, see Specifications. [1][2]Body and Frame.

Install in the reverse order.