Side Panel Loadspace

Side panel loadspace

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal





Removing the side panel





Remove:
- the load limiter in the cargo compartment as described in Luggage Compartment Cover Service and Repair
- the rear limit loader lock. See: Load limiter rear locking Load Limiter Rear Locking
- the sill molding in the cargo compartment by lifting it straight up (6 hidden clips and 2 guides).
Unplug the connectors to the sill molding.





Remove:
- the clip, x1
- the 1 x M6 nut
- the tool compartment
- the 4 x M8 lashing eyes
- the floor mat in the cargo compartment.





Note! Mark the height position of the support before removal.

Remove the screw, 1 x M6.




Carefully tap the support up.





Remove:
- the 2 M6 screws
- the support with corresponding panel
- the panel for supporting the roof in the lowered position.





Remove:
- the 4 x clips
- the 1 x M8 lashing eye

Raise the panel and angle it out over the support.

Installation

Note! For tightening torques, see Specifications. [1][2]Body and Frame.

Installing the side panel
Install in the reverse order.