Jammed

Jammed

Checking the status




- Ignition on.
Activate the windshield wiper.
Check if the fault is permanent or intermittent.
When activated, the wiper blades must move across the windshield.
The fault is permanent if the wiper blades do not activate.
If the wiper blades are activated, this is an indication that the fault was present previously but that it is not active at the moment, i.e. the fault is intermittent.

Continue - Checking the component

-------------------------------------------------

Checking the component
Check that nothing is blocking the windshield wiper blades and control arms mechanically.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Signal specification Signal Description, Central Electronic Module (CEM)
- Wiper mechanism, windshield Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Activate the windshield wipers in the intermittent wiping position.
Activate the windshield wipers in the low speed position.
Activate the windshield wipers in the high speed position.
Check that the function is OK.

Is the function OK?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component

-------------------------------------------------