Checking Insert and Eject, MD Module (MP1)

Checking insert and eject

Fault-tracing information
Check that nothing is in the way or inserted into the MD player.
Remedy as necessary.

Was a fault detected?

Yes - Remedy as necessary

No - Replacing the component

-------------------------------------------------

Replacing the component
Before continuing with fault-tracing, the following must be checked:
- All tests for the relevant symptom must have been carried out
- No component, connector or wiring faults etc. should have been detected.
Try replacing the MD module (MP1).

Caution! A new MD module (MP1) is delivered without software. The MD module (MP1) must be programmed in order to function after replacement.

Other information:
- For further information about programming and replacing the MD module (MP1), see MiniDisc / CD control module, replacing Service and Repair.

Was a fault detected?

Yes - Try replacing the MD module (MP1)

No - No Fault Found

-------------------------------------------------